API 5L X70|X70 STEEL PLATE

API 5L standard specification for line pipe

The purpose of this specification is to provide standards for pipe suitable for use in conveying gas, water, and oil in both the oil and natural gas industries.

This specification covers seamless and welded steel line pipe. It includes plain-end, threaded-end, and belled-end pipe, as well as through-the-flowline (TFL) pipe and pipe with ends prepared for use with special couplings.

Gangsteelis specialized in supplying API 5L steel plate in X70. For more information of API 5L X70 steel plates, please check them in following:

1. The minimum elongation in 2 in. (50.8 mm) shall be that determined by the following equation:

U.S.Customary Unit Equation: e= 625,000*A^0.2/U^0.9; SI Unit Equation: e= 1,944A^0.2/U^0.9

Where e= minimum elongation in 2 in. (50.8 mm) in percent rounded to the nearest percent.

A= applicable tensile test specimen area, as follows:

1. For round bar specimens:

-----0.20 in.² (130 mm2) for the 0.500 in. and 0.350 in. specimens,

-----0.10 in.² (65 mm2) for the 0.250 in. specimen

  b. For full section specimens, the smaller of (i) 0.75 in.²(485 mm2) and (ii) the cross-sectional area of the test specimen, calculated using the specified outside diameter of the pipe and the specified wall thickness of the pipe, rounded to the nearest 0.01 in.²(10 mm2);

c. For strip specimens, the smaller of (i) 0.75 in.2 (485 mm2) and (ii) the cross-sectional area of the test specimen, calculated using the specified width of the test specimen and the specified wall thickness of the pipe, rounded to the nearest 0.01 in.2 (10 mm2).

U = speciÞed minimum ultimate tensile strength in psi (MPa).

Shipbuilding steel plate| Alloy steel plates| High strength plate| Carbon steel plate| Stainless steel plate

If you need more stock steel plates in pressure vessel steel plate, please click warehouse sizes.

Related Grade: X42, X46, X52, X56, X60, X65, X70